Your position: News Detail
-
The Solution to the Problem of Micro Bearing Overheat
Because the micro-bearing heat for different reasons, so the solution is different, the following is the micro-bearing temperature overheating solution:
1, fat-filled method, the so-called fat-filled method is to work regularly to the bearing surface filled with the right amount of grease is one of the most commonly used grease lubrication.
2, the oil cup method, oil cup method is set in the bearing block cap oil cup or pressure oil cup, rotating the spin screw cap or oil gun into the grease. This is also a common grease lubrication.
3, the pressure for the fat method, the pressure for fat method is to rely on grease pump for fat. At this point should use a good fluidity grease.
4, concentrated for the fat method, the concentration of fat through the grease pump, while the various deep groove ball bearings and other components for fat. Similarly, the grease should be used at this time flowing good, oxidation resistance and corrosion resistance of the grease, but also a pressure for the fat method.
